More Horizontal Stab and the Pneumatic Squeezer arrived.

So in the last post I mentioned that I needed to order a longeron or flange-nose yoke for my Main Squeeze squeezer from Cleaveland Tool. I got on their website Monday to order and realized that my arms and shoulders were still hurting from using the manual squeezer. So I took the plunge and bought their pneumatic squeezer kit. I emailed Mike and asked if they could substitute the flange-nose yoke for the 3″ yoke that comes standard with the kit, as I already had the yoke with my Main Squeeze. Mike emailed me back right away and said it was no problem. I completed the order with Annette, and everything arrived Wednesday. I’m 4 for 4 on great service by Mike, Annette and the rest of the crew at Cleaveland!

After getting things set up last night (Friday) I had a cinch job of finishing up the rest of the rivets in the front horizontal stabilizer spar thanks to the new squeezer. I’m looking forward to more rivets to squeeze.

I also countersunk the 400+ holes in both spars and the stringers and prepped both skins today with Prekote and maroon Scotchbrite. Prekote says to prime aluminum within 24 hours of prep, so I’ll warm up the garage first thing in the morning and prime the skins inside and out. And then use the leftover AKZO and a Q-Tip to touch up all the countersinks I made on the spars and stringers.

And my Amazon-provided torque wrench also arrived on Thursday, so I finished bolting the elevator center hinge bearing bracket onto the rear spar, then torque sealed it.

Leave a Reply

Your email address will not be published. Required fields are marked *